Outlining the base shapes of the head contour is important for applying shape templates in CrazyTalk. In the Face sub-step, set the feature points and lines as close as possible to the natural shape of the head.
Click on any point to transform the outline of the head contour, or click on the line segments to drag the entire wireframe into position.
The initial position detected by CrazyTalk | The head shape of the 3D actor is similar but not very alike the one in the photo. |
Manually adjust the points to match the head in the photo. | The head of the 3D head looks almost the same as the one in the photo. |
After deforming the head shape by fitting the feature points, if you need to fine-tune the angle of the ears, the thickness of the cheeks and chin, then you can drag the highlighted areas as shown below to adjust them.
The dragging in the morph areas maps to the facial feature sliders in the Detail Morph step. Refer to the Fine-tuning with Detail Morph section for more information.