Adjusting Emitters
If you totally understand how the emitter links to its parent, please read
the following section for further adjustments to the emitter itself.
Please visit the
official web site for
the particle introduction.
Emitter Settings |
||||||
Emit On/Off |
You may define when the emitter starts to emit and when to stop by clicking the On/Off buttons in the Emitter Settings section. Once you click any one of the two buttons, you set an Emit key on the timeline. Therefore, one emitter is able to send particles intermittently. |
|||||
Quota |
|
|||||
Emit Volume |
Please keep in mind first that there is an invisible cube container in which emitters distribute averagely.
|
|||||
|
||||||
Direction |
With the idea of a longitude and latitude system, the emitter obtains the direction for sending off the particles. Please notice that the effect can be observed when the Velocity parameter increases.
|
|||||
|
||||||
Spread |
To understand these two parameters, you must think of a pyramid in your mind first. The top of the pyramid is the position for the emitter and it ejects particles straight to the bottom of the pyramid.
|
|||||
|
||||||
Velocity |
||||||
|
||||||
|
||||||
|
Please refer to the Moving, Rotating Emitters section for more information.