Marking Facial Features (New for Version 8)

By setting the feature points to the correct positions on the face, you are able to roughly determine the position of the facial features. Please follow the steps below:

1. Notice the instruction image at the upper-left side of the panel. It shows the proper position for the current feature point.
   
2. Click on the indicated position on the imported photo.
   
   
3. The instruction image will show you the position for setting the next feature points.
   
4. Follow the instructions to finish setting all the feature points.
   
5. Click the Next button when finished.
   Note

   • If you have imported a side image, then the next procedure will be setting the feature points for the side face as described in the next section.
   • If you did not import a side image, then the next procedure will be choosing the base head for the actor.

If you have imported an image of side face in the previous procedure, then you need to mark the facial features to depict the profile of the actor; otherwise, you can skip this section.

1. Notice the instruction image at the upper-left side of the panel. It shows the proper position for setting the current feature point.
   
2. Click on the indicated position on the imported photo.
   
   
3. The instruction image will show you the position for setting the next feature points.
   
4. Follow the instructions to finish setting all the feature points.
   
5. Click the Next button to go for the next procedure, Selecting 3D Face Profile.